Replacement RX-7 Flash-To-Pass Light Lenses

A simple replacement for the factory flash-to-pass (FTP) light lenses.

Made of transparent gray acrylic with high quality stainless steel screws and nylon-insert stainless steel locking nuts. Sold as a pair of lenses with all necessary hardware included.

The two studs on the original lens, set in plastic, are prone to breaking over time, at which point they like to fall out and are sometimes ran over. Although the studs can be repaired, they often snap off in a new location.

Installation is simple: Push the screws through the lens, slide the spacers on (long piece onto the outboard side, short piece onto the inboard side), then poke the threads through their mounting points on the car and tighten the nuts. Do not overtighten them, just snug is fine. Some trimming of the spacers may be required to fit your car just right.

Fluorescent amber, blue, green, or red also available by special order.

$30.00

Add to Cart:



Copyright © 2017 13B Etc.